HP LaserJet Enterprise 700 - Configure fax dialing settings

Congure fax dialing settings
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Fax Settings
●
Fax Send Settings
●
Fax Send Setup
●
Fax Dialing Settings
Congure any of the following settings:
Menu item Description
Fax Dial Volume Use the Fax Dial Volume setting to control the product's dialing volume level when
sending faxes.
Dialing Mode The Dialing Mode setting sets the type of dialing that is used: either tone (touch-tone
phones) or pulse (rotary-dial phones).
Fax Send Speed The Fax Send Speed setting sets the modem bit rate (measured in bits per second) of the
Analog Fax modem while sending a fax.
●
Fast (default) — v.34/max 33,600 bps
●
Medium — v.17/max 14,600 bps
●
Slow — v.29/max 9,600 bps
Redial Interval The Redial Interval setting selects the number of minutes between retries if the number
dialed is busy or not answering, or if an error occurs.
NOTE: You might observe a redial message on the control panel when both the Redial
On Busy and Redial On No Answer settings are set to o. This occurs when the fax
accessory dials a number, establishes a connection, and then loses the connection. As a
result of this error condition, the fax accessory performs three automatic redial attempts
regardless of the redial settings. During this redial operation, a message displays on the
control panel to indicate that a redial is in progress.
Redial on error The Redial on error feature sets the number of times a fax number will be redialed when
an error occurs during a fax transmission.
Redial On Busy The Redial On Busy setting selects the number of times (0 through 9) the fax accessory
redials a number when the number is busy. The interval between retries is set by the
Redial Interval setting.
Redial On No Answer The Redial On No Answer setting selects the number of times the fax accessory redials if
the number dialed does not answer. The number of retries is either 0 to 1 (used in the
U.S.) or 0 to 2, depending on the country/region setting. The interval between retries is
set by the redial interval setting.
Detect Dial Tone The Detect Dial Tone setting determines whether the fax checks for a dial tone before
sending a fax.
Dialing Prex The Dialing Prex setting allows you to enter a prex number (such as a "9" to access an
outside line) when dialing. This prex number is automatically added to all phone
numbers when dialed.
178 Chapter 8 Fax ENWW