Fuser motor assembly
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 21.
●
Formatter PCA. See
Formatter PCA on page 74.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 24.
●
Rear door (simplex products). See
Rear door (simplex product) on page 26.
●
Rear cover (simplex products). See
Rear cover and feed guide (simplex product) on page 30.
●
Upper-cover assembly. See
Upper-cover assembly on page 41.
●
Control-panel assembly. See
Control-panel assembly on page 50.
●
Right panel. See
Right panel on page 52.
Remove the fuser motor assembly
1. Remove four flat-head screws (callout 1), three screws (callout 2), and then remove the sheet-metal
plate.
CAUTION: The four flat-head screws must be installed in the correct position to avoid damage to
the formatter. Standard screws can contact the formatter when it is installed and can cause a
formatter short circuit.
Figure 1-111 Remove the fuser motor assembly (1 of 4)
1
2
78 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...