Replace the pickup roller
The roller must be rotated into the service position to remove it.
CAUTION: Avoid touching the spongy roller surface unless you are going to replace the roller. Skin
oils on the roller can cause paper-pickup problems.
1. Turn the product on, and wait for it to reach the Ready state. Perform the following steps to rotate
the roller to the service position.
NOTE: If you have removed Tray 2 to service the product, reinstall the tray before turning the
product on.
TIP: The following steps rotate the engine paper-pickup roller
and
the Tray 1 paper-pickup roller
into the service position.
a. Open the 2ndry Service menu by pressing the Left Arrow button and the Cancel button
simultaneously.
b. Use the arrow buttons to select Pick roller, and then press the OK button.
Press the OK button again to confirm that you want the roller to rotate.
c. Listen for the roller to rotate. When the roller is done rotating, unplug the power cord, and
then place the power button in the off position.
CAUTION: It is important to place the power button in the off position
after
unplugging the
power cord so that the product power does not come on immediately when the power cord is
plugged in again.
d. Remove Tray 2.
e. Perform the remaining steps in this procedure to remove the roller. After replacing the roller,
plug the power cord into the product, and then use the power button to turn the product on.
10 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...