10. Remove the front-door assembly.
Figure 1-89 Remove the front-door assembly (10 of 10)
Reinstall the front-door assembly
Use this procedure if you are installing a
replacement
front-door assembly.
1. Open Tray 1, and then rotate the retainer arm until the tabs on the arm-hinge pin align with the
slots in the mounting hole on Tray 1.
Figure 1-90 Reinstall the front-door assembly (1 of 2)
1
62 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...