HP LaserJet Pro 400 color M451 - Paper-delivery assembly

Paper-delivery assembly
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 21.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 24.
●
Rear door (simplex products). See
Rear door (simplex product) on page 26.
●
Rear door (duplex products). See
Rear door (duplex product) on page 28.
●
Rear cover (simplex products). See
Rear cover and feed guide (simplex product) on page 30.
●
Upper-cover assembly. See
Upper-cover assembly on page 41.
●
Left cover. See
Left cover on page 44.
●
Rear-lower cover (duplex products). See
Rear-lower cover and rear-door links (duplex product)
on page 34.
Remove the paper-delivery assembly
1. Disconnect two connectors (callout 1), and then release the wire harnesses from the retainer
(callout 2).
Figure 1-142 Remove the paper-delivery assembly (1 of 4)
1
2
98 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com