Intermediate transfer belt (ITB)
1. Remove the print-cartridge drawer. See Print-cartridge drawer on page 18.
2. Open the front door, and then remove two screws (callout 1).
Figure 1-92 Remove the ITB (1 of 6)
1
3. Carefully rotate the color misregistration sensor away from the ITB.
CAUTION: The sensor is still attached to the left side of the product and cannot be completely
removed.
Figure 1-93 Remove the ITB (2 of 6)
64 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...