Fan
1. Remove the right cover. See Right cover on page 21.
2. Disconnect one connector (callout 1) and then release the wire harness from the retainer
(callout 2).
Figure 1-127 Remove the fan (1 of 2)
2
1
3. Release one tab (callout 1), push down on the fan to release it from the mounting points
(callout 2), and then remove the fan.
Figure 1-128 Remove the fan (2 of 2)
2
1
88 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...