Rear-door stopper and link caps (simplex product)
1. Open the rear door.
2. Use a pair of needle-nose pliers to release two tabs, and then remove the link cap.
TIP: It might be easier to remove the link caps if you remove the feed assembly. See Paper-feed
guide assembly on page 48.
Figure 1-27 Remove the rear-door stopper and link caps (simplex product) (1 of 2)
3. Use a small, flat-blade screwdriver to carefully remove the remaining link cap, and then remove
the rear-door stopper.
Figure 1-28 Remove the rear-door stopper and link cap (simplex product) (2 of 2)
ENWW
Removal and replacement procedures
25
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...