Menu item Sub-menu item Description
Archive Print On
Off*
If you are printing pages that will be stored for a long
time, use this option to set the product to a mode that
reduces toner smearing and dusting.
Firmware Date Displays the current firmware datecode.
Restore Defaults Sets all customized menu settings to the factory
default values.
HP Smart Install On*
Off
Enable or disable the HP Smart Install tool.
Disable the tool if you want to connect to a network
by using an Ethernet cable.
Network Setup menu
Use this menu to establish network configuration settings. Items that have asterisks (*) indicate the
factory default setting.
Menu item Sub-menu item Description
Wireless Menu (wireless products
only)
NOTE: You can also access this
menu by pressing the Wireless
button on the front of the product.
Direct WiFi Provides the product's Direct Wifi name, so you can
access it from other wireless devices that support the Wi-Fi
Direct protocol.
WPS Setup If your wireless router supports this feature, use this method
to set up the product on a wireless network. This is the
simplest method.
Network Test Tests the wireless network and prints a report with the
results.
Wireless Off/On Enable or disable the wireless network feature.
TCP IP Config Automatic*
Manual
Select the Automatic option to automatically configure all
the TCP/IP settings.
Select the Manual option to manually configure the IP
address, subnet mask, and default gateway.
Auto Crossover On*
Off
Enables or disables the use of a standard 10/100
network cable when the product is directly connected to a
computer.
Network Services IPv4
IPv6
Enable or disable the IPv4 and IPv6 protocols. By default,
each protocol is enabled.
Show IP Address No
Yes*
No: The product IP address will not appear on the control
panel display.
Yes: The product IP address will appear on the control
panel display.
130 Chapter 2 Solve problems ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...