2. Release two tabs (callout 1), and then remove the power button.
Figure 1-66 Remove the right-front cover and power button (2 of 2)
1
Paper-feed guide assembly
NOTE: A simplex model is shown below. Duplex and simplex models use the same paper-feed guide
assembly, and the removal and replacement processes are identical.
1. Remove one screw (callout 1).
CAUTION: The bushing on this screw is not captive. Do not lose the bushing when the screw is
removed.
Figure 1-67 Remove the feed assembly (1 of 2)
1
48 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...