Control-panel assembly
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 21.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 24.
●
Upper-cover assembly. See
Upper-cover assembly on page 41.
Remove the control-panel assembly
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do
not straighten prefolds in the FFCs. You
must
ensure that all FFCs are fully seated in their connectors.
Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
1. Disconnect one FFC (callout 1), and then remove one screw (callout 2).
Figure 1-69 Remove the control-panel assembly (1 of 3)
2
1
50 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...