HP LaserJet Pro 400 color M451 - Right-front cover and power button

Right-front cover and power button
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 21.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 24.
●
Upper-cover assembly. See
Upper-cover assembly on page 41.
●
Control-panel assembly. See
Control-panel assembly on page 50.
●
Right panel. See
Right panel on page 52.
Remove the right-front cover and power button
1. Lift up on one tab (callout 1) and then slide the right-front cover toward the top edge of the right
panel to separate the cover from the panel.
Figure 1-65 Remove the right-front cover and power button (1 of 2)
1
ENWW
Removal and replacement procedures
47
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com