Front-door assembly
Before proceeding, remove the following components:
●
Print-cartridge drawer. See
Print-cartridge drawer on page 18
●
Right cover. See
Right cover on page 21.
●
Upper-cover assembly. See
Upper-cover assembly on page 41.
●
Left cover. See
Left cover on page 44.
●
Rear door (simplex products). See
Rear door (simplex product) on page 26.
●
Rear cover (simplex products). See
Rear cover and feed guide (simplex product) on page 30.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 24.
●
Rear door (duplex products). See
Rear door (duplex product) on page 28.
●
Rear-lower cover (duplex products). See
Rear-lower cover and rear-door links (duplex product)
on page 34.
●
Control-panel. See
Control-panel assembly on page 50
●
Right panel. See
Right panel on page 52.
Remove the front-door assembly
1. Find the front-door pin on the left-side door link.
Figure 1-80 Remove the front-door assembly (1 of 10)
ENWW
Removal and replacement procedures
57
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...