4. Disconnect one connector (callout 1).
Figure 1-94 Remove the ITB (3 of 6)
2
5. Carefully lift up on the front of the ITB to release it.
CAUTION: Avoid touching the black plastic transfer belt. Skin oils on the belt might cause print-
quality problems. Lift the ITB as shown below by using the hard-plastic edges of the ITB.
Figure 1-95 Remove the ITB (4 of 6)
ENWW
Removal and replacement procedures
65
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...