3. Release the wire harness from the guide (callout 1).
NOTE: When you remove the sensor assembly later in this procedure, pass the connector and
wire harness through the hole in the chassis (callout 2).
Figure 1-122 Remove the color-misregistration sensor assembly PCA (2 of 4)
1
2
4. Remove two screws (callout 1).
Figure 1-123 Remove the color-misregistration sensor assembly PCA (3 of 4)
5
ENWW
Removal and replacement procedures
85
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...