Menu item Sub-menu item Sub-menu item Sub-menu item Description
Print Quality Calibrate Color After Power On
Calibrate Now
After Power On: Select how soon the product
should calibrate after you turn it on. The default
setting is 15 Minutes.
Calibrate Now: Makes the product perform a
calibration immediately. If a job is processing,
the product calibrates after the job is complete. If
an error message displays, you must clear the
error first.
Adjust Alignment Print Test Page Use this menu to shift the margin alignment to
center the image on the page from top to bottom
and from left to right. Before adjusting these
values, print a test page. It provides alignment
guides in the X and Y directions so you can
determine which adjustments are necessary.
Adjust Tray <X> X1 Shift
X2 Shift
Y Shift
Use the X1 Shift setting to center the image from
side to side on a single-sided page or for the
second side of a two-sided page.
Use the X2 Shift setting to center the image from
side to side on the first side of a two-sided page.
Use the Y Shift setting to center the image from
top to bottom on the page.
Energy Settings Sleep Delay 15 Minutes*
30 Minutes
1 Hour
2 Hours
Off
1 Minute
Sets how long the product remains idle before it
enters Sleep mode. The product automatically
exits Sleep mode when you send a print job or
press a control panel button.
NOTE: The default Sleep Delay time is 15
minutes.
Auto Power Down Power Down Delay 30 Minutes*
1 Hour
2 Hours
4 Hours
8 Hours
24 Hours
Never
Select the length of time after which the product
automatically turns off.
NOTE: The default Power Down Delay time is
30 minutes.
Wake Events USB Job
LAN Job
Wireless Job
Button Press
Select whether the product wakes when it
receives each of these types of jobs or actions.
The default for each option is Yes.
126 Chapter 2 Solve problems ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...