5. Rotate the top of the retainer away from the chassis, and then lift it up to remove it.
Figure 1-102 Remove motor M1 and motor M2 (4 of 5)
6. Remove three screws (callout 1) to remove motor M1, or remove three screws (callout 2) to remove
motor M2.
Figure 1-103 Remove motor M1 and motor M2 (5 of 5)
1
2
70 Chapter 1 Removal and replacement ENWW
For mor information on LaserJet Pro 300, Pro 400 go to www.printersupplies.com
To Next Page
Loading...