Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
The show sflow <instance> destination command includes information about
the management-station’s destination address, receiver port, and owner.
ProCurve# show sflow 2 destination
Destination Instance 2
sflow Enabled
Datagrams Sent 221
Destination Address 10.0.10.41
Receiver Port 6343
Owner Administrator, CLI-owned, Instance 2
Timeout (seconds) 99995530
Max Datagram Size 1400
Datagram Version Support 5
Figure 14-14. Example of Viewing sFlow Destination Information
Note the following details:
■ Destination Address remains blank unless it has been configured.
■ Datagrams Sent shows the number of datagrams sent by the switch
agent to the management station since the switch agent was last
enabled.
■ Timeout displays the number of seconds remaining before the switch
agent will automatically disable sFlow (this is set by the management
station and decrements with time).
■ Max Datagram Size shows the currently set value (typically a
default value, but this can also be set by the management station).
The show sflow <instance> sampling-polling [port-list] command displays infor-
mation about sFlow sampling and polling on the switch. You can specify a list
or range of ports for which to view sampling information.
14-31
To Next Page
Loading...
