171
The IP address used by the user to access the network must be within this IP address
group.
e. Click OK.
5. Select Access Service > Service Parameters > Validate System Configuration from the
navigation tree to validate the configurations.
Configuring the portal authentication server on IMC PLAT 5.0
In this example, the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1. Configure the portal authentication server:
a. Log in to IMC and click the Service tab.
b. Select User Access Manager > Portal Service Management > Server from the
navigation tree to open the portal server configuration page, as shown in Figure 51.
c. Config
ure the portal server parameters as needed.
This example uses the default settings.
d. Click OK.
Figure 51 Portal server configuration
2. Configure the IP address group:
a. Select User Access Manager > Portal Service Management > IP Group from the
navigation tree to open the portal IP address group configuration page.
b. Click Add to open the page as shown in Figure 52.
c. Enter the IP group n
ame.
d. Enter the start IP address and end IP address of the IP group.
Make sure the host IP address is in the IP group.
e. Select a service group.
This example uses the default group Ungrouped.
f. Select the action Normal.
g. Click OK.
To Next Page
Loading...
Need help?
General