HPE ProLiant DL385 Gen10 - Page 12

Item Description Status
1 Health LED
1
• Solid green = Normal
• Flashing green (1 Hz/cycle per sec) = iLO is
rebooting
• Flashing amber = System degraded
• Flashing red (1 Hz/cycle per sec) = System critical
2
2 Power On/Standby button and
system power LED
1
• Solid green = System on
• Flashing green (1 Hz/cycle per sec) = Performing
power on sequence
• Solid amber = System in standby
• Off = No power present
3
3 NIC status LED
1
• Solid green = Link to network
• Flashing green (1 Hz/cycle per sec) = Network
active
• Off = No network activity
4 UID button/LED
1
• Solid blue = Activated
• Flashing blue:
◦ 1 Hz/cycle per sec = Remote management or
firmware upgrade in progress
◦ 4 Hz/cycle per sec = iLO manual reboot
sequence initiated
◦ 8 Hz/cycle per sec = iLO manual reboot
sequence in progress
• Off = Deactivated
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health
status.
3
Facility power is not present, the power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the power button cable is disconnected.
12 Component identification