hpmont HD30 Series - Chapter 3 Mechanical Installation; 3.1 Installation Precautions; 3.2 Requirement for the Installation Site

Shenzhen Hpmont Technology Co., Ltd Chapter 3 Mechanical Installation
HD30 Series Inverters User Manual ―11―
Chapter 3 Mechanical Installation
3.1 Installation Precautions
• Do not install if the inverter is imcomplete or impaired.
• Make sure that the inverter is far from the explosive and flammability things.
• Do not operate the inverter until the power is cut-off 10 minutes later.
• It is required not only carry the display panel and the cover but also the inverter bottom enclosure.
• Do not play metal into the inverter when installing.
3.2 Requirement for the Installation Site
Ensure the installation site meeting the following requirements:
• Do not install at the direct sunlight, moisture, water droplet location;
• Do not install at the flammability, explosive, corrosive gas and liquid location;
• Do not install at the oily dust, fiber and metal powder location;
• Be vertical installation on fire-retardant material with a strong support;
• Make sure adequate cooling space for the inverter so as to keep the ambient temperature
between - 10－+ 40℃;
• Install at where the vibration is less than 5.9m/s
2
(0.6g).
Note:
1. It needs derating use if the inverter operation temperature exceeds 40
℃
. The derating value of
the output current of the inverter shall be 2% for each degree centigrade. Max. allowed
temperature is 50
℃
.
2. Keep ambient temperature between -10
－
+40
℃
. It can improve the inverter operation
performance if install at the location with good ventilation or cooling devices.
Danger
Warning
3