Huawei FusionModule800 Installation Guide

FusionModule800 Smart Small Data Center
Installation Guide (Six Fans)
3 Hardware Installation
Issue 10 (2019-12-20)
Copyright © Huawei Technologies Co., Ltd.
101
Applicable
Scenario
No.
Cable
Name
From
To
Cable
Specifications
Remarks
power cable
8
J3 cable
X101,
X102, and
X103 ports
on the
indoor unit
J3 port on the
smart cooling
product control
unit
N/A
Connected onsite
9
J4 cable
X101,
X102, and
X103 ports
on the
indoor unit
J4 port on the
smart cooling
product control
unit
N/A
Connected onsite
10
T/H sensor
cable
T/H sensor
RS485/12 V
port on the
smart cooling
product control
unit
Two shielded
twisted pairs, 26
AWG
Connected onsite
11
Energy
control
center 800
(ECC800)
cable
FE-2 port
on the
control unit
PoE port on the
smart ETH
gateway
Four shielded
twisted pairs, 24
AWG

If the smart
ETH gateway
is configured,
connect the
cable to the
PoE port on
the smart ETH
gateway.

If no smart
ETH gateway
is configured,
connect the
cable to the
WAN_2 port
on the
ECC800.
12
Ground
cable
Ground
point on the
smart
cooling
product
control unit
IT cabinet
ground cable
4 mm
2
Connected onsite
Single smart
cooling
product or
double smart
cooling
products
1
Electric
heater
contactor
(required if
an electric
heater is
configured)
Converged
cabinet
XT4-6 and
XT4-5
correspond
to smart
cooling
products 1
and 2,
respectively
Contactor KM1
of the
corresponding
smart cooling
product
N/A
Factory-installed

Huawei FusionModule800 Specifications

General

Brand	Huawei
Model	FusionModule800
Category	Storage
Language	English