FusionModule800 Smart Small Data Center
Installation Guide (Six Fans)
Copyright © Huawei Technologies Co., Ltd.
Figure 6-4 Adding access permissions
You can authorize and delete access users in batches.
3. Click OK to complete the task of adding access management settings.
4. On the Authorization Operations tab page, click Synchronize to Device, select the
modified access control devices, and click Start Synchronization.
Figure 6-5 Synchronizing access permissions
5. When Synchronization Status is Synchronized for the related devices, close the
Synchronize Access Permission page.
Step 2 Set an alarm for card readers.
Set Logical level configuration for reader removed based on the fingerprint reader
configured for the access control system.
If the access control system uses a Card and password reader, choose Monitoring >
Aisle > Access Actuator Group > Access Actuator n on the ECC800 WebUI, click
To Next Page
Loading...
Need help?
General