To Next Page

To Previous Page

FusionModule800 Smart Small Data Center

Installation Guide (Six Fans)

Contents

Issue 10 (2019-12-20)

vii

4 Cable Routing ............................................................................................................................ 192

4.1 System Cabling Rules ............................................................................................................................................... 192

4.2 Cable Routes ............................................................................................................................................................. 197

4.3 Power Cable Routing ................................................................................................................................................ 204

4.4 Smart Module Grounding ......................................................................................................................................... 204

4.5 Cable Connections to the Power Supply and Distribution System ........................................................................... 206

4.5.1 Top Cable Routing ................................................................................................................................................. 206

4.5.1.1 Cable Routing Description .................................................................................................................................. 206

4.5.1.2 (Optional) Connecting Signal Cables to the Converged Cabinet ........................................................................ 209

4.5.1.3 Connecting Output Power Cables to the Converged Cabinet ............................................................................. 210

4.5.1.4 Connecting Input Power Cables to the Converged Cabinet ................................................................................ 213

4.5.2 Bottom Cable Routing ........................................................................................................................................... 216

4.5.3 Connecting a PDU2000 Power Cable .................................................................................................................... 218

4.5.4 Connecting Cables Between the Battery and the UPS ........................................................................................... 219

4.6 Management System Cable Connection ................................................................................................................... 219

4.6.1 ECC800 Ports ........................................................................................................................................................ 219

4.6.2 Connecting a Monitoring Cable to the Door Status Sensor ................................................................................... 220

4.6.3 Connecting VCN Cables ........................................................................................................................................ 221

4.6.4 Connecting a Monitoring Cable to the Smart ETH Gateway ................................................................................. 222

4.6.5 Connecting a Monitoring Cable to the AI/DI Module ........................................................................................... 223

4.6.6 Connecting the Smoke Detector Monitoring Cable ............................................................................................... 224

4.6.7 Connecting Cables to Water Sensors ..................................................................................................................... 225

4.6.8 (Optional) Connecting Cables for the In-Room Access Control System ............................................................... 226

5 Checking After Installation .................................................................................................... 228

6 Power-On Commissioning ...................................................................................................... 232

6.1 Power-On Commissioning for the ATS .................................................................................................................... 232

6.2 Power-On Commissioning for the Power Supply and Distribution System ............................................................. 233

6.3 Management System Power-On Commissioning ..................................................................................................... 235

6.3.1 Preparations and WebUI Login .............................................................................................................................. 235

6.3.2 Preparations and APP Login .................................................................................................................................. 237

6.3.3 Setting the Date and Time ...................................................................................................................................... 240

6.3.4 Creating a Micro-Module Plan View ..................................................................................................................... 240

6.3.5 Adding an Independent Deployment AI_DI Unit .................................................................................................. 240

6.3.6 Commissioning the Sensor .................................................................................................................................... 241

6.3.6.1 Commissioning the Smoke Detector .................................................................................................................. 241

6.3.6.2 Commissioning the Water Sensor ....................................................................................................................... 242

6.3.6.3 Commissioning the Temperature Sensor ............................................................................................................ 242

6.3.6.4 Commissioning the Door Status Sensor .............................................................................................................. 243

6.3.6.5 (Optional) Commissioning the In-Room Access Control System ...................................................................... 244

6.3.6.6 (Optional) Commissioning an In-Room Exit Button .......................................................................................... 247

6.3.6.7 (Optional) Commissioning an In-Room Emergency Door Release Button ........................................................ 248