iManager NetEco 6000
Device Installation and Commissioning Guide
Copyright © Huawei Technologies Co., Ltd.
Figure 6-27 Adding a camera using automatic discovery
The method of adding a camera using automatic discovery applies to all other management domains
except Subnet and Root.
After a camera is added, it will be displayed under the corresponding management domain on the
Data Center Planning page. On the Data Center Planning page, you can set parameters such as
the Name for the camera.
----End
Follow-up Procedure
Table 6-9 describes the operations that can be performed on the Discovery Camera page.
Table 6-9 Follow-up procedure
Query the information about a camera
1. On the Discovery Camera page, specify
one or multiple of the keywords Code,
Name, and IP Address.
2. Click Search.
To reset the search criteria, click Reset.
On the Discovery Camera page, click
Refresh. The camera information in the list
is refreshed.
To Next Page
Loading...
Need help?
General