Configurati
on Item
Data
E1 port
(ONU)
Board IP address: 10.10.50.20
Board MAC address: dynamically obtained (remark 1)
UDP port number: 50048 (remark 2)
VLAN SVLAN: 300
Remark 1: MAC address configuration modes (statically configured or dynamically obtained)
at two ends must be consistent to establish a SAToP connection. It is recommended that MAC
addresses be dynamically obtained, which facilitates configuration and maintenance.
Remark 2: The UDP port cannot be a port that is widely used in the industry and for specific
services. For example, port 80 is used for HTTP service. The dynamic and private ports are
recommended.
Procedure
Step 1 Configure a VLAN and add an upstream port to the VLAN.
Create the upstream VLAN 300, and add upstream port 0/0/1 to VLAN 300.
huawei(config)#vlan 300 smart
huawei(config)#port vlan 300 0/0 1
Step 2 Configure E1/T1 port attributes.
Configure the IP address of TDM service board 0/1 as 10.10.50.20.
huawei(config)#interface tdm 0/1
huawei(config-if-tdm-0/1)#set ip-address 10.10.50.20
Configure the board and port working mode and transmit clock.
l For E1 access, set the working mode to UDT and configure the transmit clock as the system
clock.
huawei(config-if-tdm-0/1)#tdm access-mode E1
huawei(config-if-tdm-0/1)#port 0 udt system
Step 3 Create a SAToP connection.
Create TDM VCL 10.
l For E1 access, set the TDM VCL type to SAToP.
huawei(config)#tdm-vcl tdm-vcl-id 10 satop 0/1/0
Create a SAToP connection at TDM port 0/1/0. Set SVLAN to 300, local UDP port number to
50048, remote IP address (the IP address of the EDTB board on the OLT) to 10.10.50.10, and
remote UDP port number to 50048. The remote MAC address is obtained dynamically.
huawei(config)#cesop-connect tdm 10 vlan 300 local-udp 50048 remote-ip 10.10.50.10
remote-udp 50048
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
13 FTTO Configuration (Large-sized Enterprise Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1354
To Next Page
Loading...
Need help?
General
