Huawei SmartAX MA5600T - Page 1870

huawei(config)#vlan service-profile profile-id 10
huawei(config-vlan-srvprof-10)#packet-policy multicast forward
Info: Please use the commit command to make modifications take
effect
huawei(config-vlan-srvprof-10)#commit
b. Enable the bridging function.
huawei(config-vlan-srvprof-10)#user-bridging
enable
Info: Please use the commit command to make modifications take
effect
huawei(config-vlan-srvprof-10)#commit
huawei(config-vlan-srvprof-10)#quit
c. Bind the VLAN service profile to the uplink VLAN.
huawei(config)#display vlan service-profile profile-id 10
Command:
display vlan service-profile profile-id
10
Profile ID:
10
Profile Name:
srvprof-10
---------------------------------------------------------------------
Parameter Committed Not
Committed
---------------------------------------------------------------------
Forwarding mode VLAN-MAC
-
BPDU tunnel disable
-
RIP tunnel disable
-
VTP-CDP tunnel disable
-
Multicast packet policy forward
-
User-bridging enable
-
OSPF tunnel enable
-
---------------------------------------------------------------------
Binding VLAN list :
0
---------------------------------------------------------------------
huawei(config)#vlan bind service-profile 101 profile-id 10
d. In ETH mode, disable the unknown multicast suppression function on the user side
interface and uplink port.
huawei(config)#interface eth 0/1
huawei(config-if-eth-0/1)#undo traffic-suppress 1 multicast
huawei(config-if-eth-0/1)#quit
huawei(config)#interface eth 0/0
huawei(config-if-eth-0/0)#undo traffic-suppress all multicast
huawei(config-if-eth-0/0)#quit
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1845