off
Color Mode : color-
blind
Referenced Status : not
used
------------------------------------------------
huawei(config)#traffic table ip index 11 cir off priority 6 priority-policy
local-Setting
Create traffic descriptor record
successfully
------------------------------------------------
TD Index :
11
TD Name : ip-traffic-
table_11
Priority :
6
Copy Priority :
-
CTAG Mapping Priority:
-
CTAG Default Priority:
0
Priority Policy : local-
pri
CIR :
off
CBS :
off
PIR :
off
PBS :
off
Color Mode : color-
blind
Referenced Status : not
used
------------------------------------------------
4. Create VLANs.
huawei(config)#vlan 100 smart
huawei(config)#vlan 101 smart
5. Add an uplink port to the VLANs.
Add uplink port 0/0/0 and 0/0/1 to the VLANs.
huawei(config)#port vlan 100 0/0 0-1
huawei(config)#port vlan 101 0/0 0-1
6. Create a service port.
For power distribution site information, create service port 2 with SVLAN 100 and traffic
profile 10. For GOOSE packets, create service port 3 with SVLAN 101 and traffic profile
11.
huawei(config)#service-port 2 vlan 100 eth 0/1/1 multi-service user-vlan
untagged
rx-cttr 10 tx-cttr 10
huawei(config)#service-port 3 vlan 101 eth 0/1/1 multi-service user-vlan 2 rx-
cttr 11 tx-cttr 11
7. Configure the bridging function for GOOSE packets.
a. Disable the unknown multicast suppression function.
Goose packets are unknown multicast packets. Disable the unknown multicast
suppression function on the OLT to ensure that GOOSE packets are not lost.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1844
To Next Page
Loading...
Need help?
General
