After the configuration, the following results should be achieved: Uses of port 0/2/31 can watch
the programs stored on servers 224.1.1.1 and 224.1.1.2, and can preview the programs stored
on server 224.1.1.3.
1. Configure the upstream port and the VLAN.
huawei(config)#vlan 100 smart
huawei(config)#port vlan 100 0/19 0-1
It will take several minutes, and console may be timeout, please use
command
idle-timeout to set time
limit
Are you sure to add standard port(s)? (y/n)[n]:y
huawei(config)#vlan 101 mux
huawei(config)#port vlan 101 0/19 0
huawei(config)#vlan 102 smart
huawei(config)#port vlan 102 0/19 0
2. Configure the traffic table.
The voice service has the highest priority, and the network access service has the lowest
priority.
Assume that the network access service uses traffic table 6, with the priority of 0. The
following shows how to create the new traffic tables for the voice service and video service
respectively.
huawei(config)#traffic table ip index 7 cir 1024 priority 7 priority-policy
Tag-In-Package
Create traffic descriptor record
successfully
------------------------------------------------
TD Index :
7
TD Name : ip-traffic-
table_7
Priority :
7
Copy Priority :
-
Mapping Index :
-
CTAG Mapping Priority:
-
CTAG Mapping Index :
-
CTAG Default Priority:
0
Priority Policy : tag-
pri
CIR : 1024
kbps
CBS : 34768
bytes
PIR : 2048
kbps
PBS : 67536
bytes
Referenced Status : not
used
------------------------------------------------
huawei(config)#traffic table ip index 8 cir off priority 5 priority-policy tag-
In-Package
Create traffic descriptor record
successfully
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
7 Example: Subtending Networking
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
527
To Next Page
Loading...
Need help?
General
