e. Configure parameters of the voice protocol.
In the navigation tree, choose General Para > Services > Voice Service > Voice
Service 1 > Interface configuration > Interface 1. Select Interface 1 and select
a proper value.
– Signaling Protocol: H.248
– Associate WAN Interface: WAN1 (binding the created voice WAN port)
NOTE
If the upper-layer network requires isolation of media streams from signaling streams, create
different traffic streams for the media streams and signaling streams on the OLT. When the
packet is forwarded from two WAN ports, the configured VLAN is carried by default. Create
a WAN port named WAN-RTP on the ONT, and set this WAN port to a media WAN port.
Specifically, choose Interface 1 > RTP and set Associate WAN Interface to WAN2.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
594
To Next Page
Loading...
Need help?
General
