18
4.6 Residual risks
Although all possible dangers have been taken into account in the design, residual risks re-
main during operation of the machine. By following these operating instructions and by work-
ing with the machine on the basis of danger, the dangers can be minimized or eliminated.
case hazards residual risk measures
When material to be com-
pacted is jamming or
bridging poking with an
object
Dangers due to
uncontrolled spin-
ning around of
objects or similar
Injuries of the upper
limbs, as well as the
head area and the upper
body.
Indicate the dangers in
the operating instruc-
tions.
During maintenance or
repair work on the ma-
chine, the system is not
disconnected from the
mains.
All hazards possib-
le
Can lead to the death of
maintenance staff.
Take the machine off
the mains and close the
main switch against
unauthorized use with
a padlock.
The machine is equipped
with four rollers and is
installed on sloping ground
> 5 °.
Unintentional roll-
ing away of the
entire machine
May cause injury such
as bruising, shearing of
the operator's upper and
lower limbs, and unin-
volved third parties.
The machine must be
prevented from rolling
away with chocks or
wedges.
Deinstallation of safety
equipment.
All hazards possib-
le
All dangers; can possi-
bly lead to the death of
the operator.
Repair safety
equipment.
DANGER!
Non-observance of this operating manual fundamentally permits all hazards that re-
sult from property damage to the death of the operator or other persons.
To Next Page
Loading...