84
15.2 Maintenance in the power pack chamber
Prior to maintenance:
When servicing the power pack chamber, appropriate safety measures must be taken to pre-
vent people from falling into the filling opening.
Open the lid of the portable compactor (if existing)
• Loosen and remove the screws of the cover above the power pack
• Open the cover
• Carry out the required maintenance in the power unit chamber
• Close the cover of the power unit chamber
• Secure the cover above the power pack with the previously removed screws
For a compactor with pendulum ram:
• Use a triangular wrench to loosen the two locks at the top of the power unit cover
• Open the cover above the power pack
• Carry out the required maintenance in the power unit chamber
ATTENTION!
•
Before checking the oil level, move the ram to the rear position and stop the
machine.
SAFETY INSTRUCTIONS before working on the machine:
•
Bring main switch to "OFF" position!
•
Secure main switch against restart! (use personal pad-
lock)
•
Pull out the mains plug!
•
Attach a suitable safety note to prevent it from being re-
connected!
WARNING!
Components of the hydraulic system can become very hot during operation.
•
Let all components cool down before performing any maintenance or work
on the hydraulic system!
To Next Page
Loading...