Husmann SPB - Page 74

To Next Page

To Previous Page

Lock the safety support again with a triangular key

Put ratchet in position "neutral"

Locking the ratchet with cotter pin or with the retaining

plate

Main Page

Table of Contents2
Preface4
Ec Declaration of Conformity5
Information Content and Rights6
General7
Manufacturers Instructions7
Contact for Machine Support7
Technical Data7
Rating Plate8
Sound Pressure Level9
Safety10
Meaning of the Safety Signal Words10
Safety11
Basic Safety Instructions11
Machine-Specific Safety Regulations13
Tipping Device14
Responsibilities of the Operator15
Warning and Information Signs16
Danger Zones19
Residual Risks21
Personal Protective Equipment23
Fire Protection23
Safety and Protective Equipment24
Intended Use28
Foreseeable Misuse29
Dimensioned Drawings of Portable Compactors30
Installation37
Installation Site37
Installation on Ramps , Pedestals and Working Patforms38
Installation in Generally Accessible Areas39
Initial Start-Up40
Electrical Connection43
Installation44
Service45
Optional Controls47
Optional Additional Equipment48
Optional Special Accessory50
Lid above the Filling Opening52
One-Piece Lid (with Gas Struts)53
Hydraulic Lid54
Lid with Linak Motor56
Centrally Divided Lid57
RAMP OPERATION with a CENTRALLY DIVIDED LID with Fall Protection (Optional)59
Lid and Tipping Device (Optional)61
Tipping Device (Optional)62
Lid and Tipping Device Variations63
Side and Top Hinged Doors66
Side Hinged Door66
Opening the Side Hinged Door on the Transport Vehicle or When the Container Is on the Ground66
Top Hinged Door69
Opening the Top Hinged Door on the Transport Vehicle69
Opening the Top Hinged Door When the Machine Is on the Ground71
Emptying Containers75
Emptying Process (Side Hinged Door)75
Emptying Process (Top Hinged Door)78
Transport80
Means of Transport80
Transport of the Machine82
Maintenance83
Operational Maintenance84
Maintenance in the Power Pack Chamber87
Checking the Oil Level89
Replacement of Oil Filter90
Maintenance in the Cylinder Chamber92
Lubrication Charts and Instructions94
Maintenance Tools104
Lubricant List104
Oil Types104
Filters104
Malfunction and Fault Table105
Decommissioning107
Temporary Decommissioning107
Disassembly and Final Decommissioning108
Check Book109
Basic Data110
Test Protocol111

Husmann SPB - Page 74

Table of Contents