The lower line of the display shows the default setting of 23:00
hours.
2. Turn the Lower Line knob to set the number of hours.
3. Turn the Upper Line knob to the right once more to select the
number of minutes.
4. Turn the Lower Line knob to set the water window minutes
(00 to :59).
Note: The minimum window you can set is 6 hours.
Setting the High ET Start
With WeatherTRAK ET plus, you set a high ET start time for when the
controller needs to water more than once per day to adjust for
extreme weather conditions.
During periods of high ET, WeatherTRAK ET plus may water every
day of the week using a single start time. If more water is needed
within a given day (typically for turf), WeatherTRAK ET plus will
irrigate a second cycle long enough to replenish the required ET.
To do this:
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to set the high ET start hour (1 to 9).
The lower line of the display shows the default setting of 1 p.m.
3. Turn the Upper Line knob to the right once more to select the
high ET start minutes.
4. Use the Lower Line knob to change the high ET start minutes (00
to :59).
To Next Page
Loading...