Reading from left to right, the upper line of the display shows:
• STA 03 Station Number
• 12.0 MIN Runtime in Minutes
• 06X Number of Cycles
• U-NO Program Mode
Reading from left to right, the lower line of the display shows:
• Int 05 Watering Day Interval
• To Go 02 Number of Days to Next Water Day
• Soak 10 Soak Time
5. Turn the Upper Line knob to REVIEW the next station(s).
If you hold down the Copy button, the display will look like this:
Reading from left to right, the upper line of the display shows:
• STA 03 Station Number
• 12.0 MIN Runtime in Minutes
• 06X Number of Cycles
• U-NO Program Mode
Note: The examples shown are just part of a larger set of displays
that can occur as the schedules and programming change.
Adjusting
The ADJUST feature is for tweaking any stations running in the “Fully
Automated” mode. The ADJUST feature can increase or decrease a
station’s runtime from the automatically calculated runtime.
Important:
Use ADJUST on any stations that are continually wetter or drier
than desired.
The ADJUST feature should not be confused with or compared to the
Water Budget feature seen in other controllers.
In the “Fully Automated” mode and the “User Programmed--With
ET” mode, the WeatherTRAK ET Everywhere service updates
automatically modify the irrigation schedule to respond to current
water requirements based on actual weather.
To Next Page
Loading...