The Display is Blank
1. Turn the Function Selector to RUN. You should now see a
display.
2. If not, power down the unit, wait for 30 seconds and restart the
unit. The display should return.
3. If the display does not return, call HydroPoint Customer Service
at: (800) 362-8774.
The Display is Frozen
1. Turn the Function Selector to RUN. The display should change
and show the date and time.
2. If the display shows “PHASE” on the lower line: The Copy
button may be stuck in the “pressed” position. Free the Copy
button.
3. If the Copy button was stuck: The controller may have been
initialized.
4. If the controller was initialized: You must reenter all the
setup, schedule and program information. You may need to
reactivate the controller. Call HydroPoint Customer Service at:
(800) 362-8774.
5. If the Copy button was not stuck: The controller may
need to be initialized. Call HydroPoint Customer Service at:
(800) 362-8774.
ET Display has a “P” After It
1. Turn the Function Selector to RUN. Check the “Date” and
“Time” settings. Be sure they are correct.
2. Turn the Function Selector to DIAGNOSTICS. If you see a “P”
after ET, the controller is currently running and an ET was
communicated to the unit during station operation. The
controller will label the ET as “Pending” until the irrigation
cycle(s) are complete. It will then apply the new ET to all
programs for the next irrigation.
Troubleshooting Guide92
To Next Page
Loading...