Week 1 in the Review Screen is Much Different
1. When the controller is installed, any days previous to today will
not be shown in “Week 1” schedule. The controller shows what
days have irrigated or it anticipates what days will irrigate if the
weather remains as it is today. If the controller is installed on a
Friday, there will be no irrigation days shown prior to Friday,
which may result in no irrigation days at all for week 1.
2. Turn the Lower Line knob to see Week 2 through 8 irrigation
days. The irrigation days will display a pattern as you look at
subsequent weeks.
The Display in REVIEW Shows “99+” Minutes
1. The runtime programmed is greater than 99 minutes. There are
only two digits available in the display to show the runtime, so if
the time actually exceeds 99 minutes it shows “99+”.
2. This is a display issue only; the controller will irrigate for the
full runtime.
Troubleshooting Guide 93
To Next Page
Loading...