HydroPoint WeaterTRAK ET plus - Setting Auto Daylight Savings; Setting the Maximum Active Stations

Setting Auto Daylight Savings
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select “Yes” or “No.”
Setting the Maximum Active Stations
You should always set the maximum active stations to correspond to
the actual number of valves that are wired to the controller.
Important:
If you set this higher than the actual number of valves that you
are using, you may add unnecessary time to the irrigation
window. This may cause unnecessary water window alerts.
Important:
If you set “Maximum Active Stations” lower than the actual
number of valves that you are using, you will prevent some of
the valves from operating at all.
There is a separate master valve terminal on the output board
of the controller. You do not need to count the master valve as
an active station.
To set the maximum active stations:
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select the number of valves
connected to the controller. The default number is 9 or 12
depending on the controller model you are operating.
SET MAX ACTIVE STATIONS
9
!
!
AUTO DAYLIGHT SAVINGS?
Yes
Setting Up Your WeatherTRAK ET plus 17