HydroPoint WeaterTRAK ET plus - Setting the Zip Code; Setting the ET Zone; Appendix A: Quick Reference Guide; Getting Started

Setting the Zip Code
To set your zip code:
1. Under SETUP, turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select a number from “0” to “9.”
3. Continue to turn the Upper Line and Lower Line knobs until
you have selected the correct five-digit zip code.
Setting the ET Zone
The ET zone number is provided at activation. Along with the
microzone value it is used by the controller to receive its local ET
updates. In most locations, you will not be required to set this at
activation.
To set the ET zone number:
1. Under “Setup,” turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select a number from “0” to “9.”
3. Continue to turn the Upper Line and Lower Line knobs until
you have selected the correct five-digit zone number.
SET ET ZONE# Digit 1
12345
–
SET ZIP CODE Digit1
15645
–
Using Special Features 79