The lower line indicates that no irrigation will occur until the
Function Selector knob is turned to another position.
Once the Function Selector knob is turned to OFF and it remains in
the OFF position for at least one second, all active controller functions
are stopped until you return the Function Selector knob to the RUN
position (or any other function position). This prevents momentary
interruption of any irrigation when rotating the Function Selector
knob through the OFF position.
Activating WeatherTRAK Rain Service
WeatherTRAK Rain Service monitors the rainfall in your area with a
sophisticated array of rain sensors and other weather devices. The
rainfall amount is then sent to your controller with the daily ET
Everywhere service broadcast. The rainfall is then used to calculate a
new soil depletion value to take advantage of the rainfall in its
calculating of the next day’s irrigation schedule.
WeatherTRAK Rain Service is available in some markets. This service
can only be activated by calling HydroPoint Customer Service at:
(800) 362-8774.
1. Under SETUP, turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select “Yes” or “No.”
Note: This display is only adjustable after Rain Service activation
by HydroPoint Customer Service.
To Next Page
Loading...