Note: If your controller is in RAIN PAUSE and you need to either
increase or decrease the number of days before it resumes normal
irrigation, turn the Function Selector knob to RAIN PAUSE and
change the number of days with the Lower Line knob.
If the rain switch is tripped, no stations will run.
If you have installed and activated a rain switch, the display will look
like this when the rain switch is active:
The upper line shows the current date and time.
The lower line shows that all programmed stations of the controller
are affected by the rain sensor and that there are no stations on in the
MANUAL mode.
Watering Manually
Manual operation allows you to immediately start irrigation of all
stations or single station(s). Manual operation is for a specified
number of minutes and will start immediately, whether or not the
current day is an allowed irrigation day. Only one station can be on at
a time when watering in MANUAL.
The steps to manually operating your controller are:
1. Manual Water Specific Stations
This involves manually watering individual stations.
2. Minutes
These are the minutes that manual operation will run.
3. Manual Water All Stations
This involves manually watering all stations with the same
runtime.
Note: Manual operation is useful to test your system to ensure
that all the sprinklers are working properly and are correctly
identified.
To Next Page
Loading...