The steps to use the RAIN PAUSE feature are:
1. Rain Pause
This turns off all stations of the controller.
2. Days to Resume
This sets the number of days to pause.
Rain Pause
Turn the Function Selector knob to RAIN PAUSE.
The display will look like this:
Days to Resume
1. Turn the Lower Line knob to:
• 00 to 14 Days (Default Setting: 00).
No irrigation will occur until RAIN PAUSE has counted down to
zero; irrigation will then resume for all stations on the next scheduled
Water Day. (As each day elapses, this display will update to show the
number of days remaining until it will resume normal irrigation.)
RAIN PAUSE has no effect on manual operations.
2. Turn the Function Selector knob to RUN. The display will look
like this:
The upper line shows the current date and time.
The lower line shows that all programmed stations of the
controller are in RAIN PAUSE and that there are no stations on
in the MANUAL mode.
To Next Page
Loading...