Setting Schedules
Schedules are water days that you can assign on a station-by-station
basis. You must set a schedule before you begin any programming.
There can be up to two different schedules:
•Aor
• B.
Once you create a schedule, you can then apply it to a given station
during programming. You can assign only one schedule for each station.
Note: Schedules do not determine or affect runtimes. Runtimes are
determined when you program each station. These schedules are
used for “Fully Automated” mode stations only. You will create
schedules for the “User Programmed–with ET” and “User
Programmed--NO ET” modes in the program sections for those stations.
To set up a schedule:
1. Turn the Function Selector knob to SCHEDULE.
You will see the following display:
2. Turn the Lower Line knob to select one of the following:
• A (Default Setting) or
•B.
3. Turn the Upper Line knob until you see:
4. Turn the Lower Line knob to choose one of the following:
• Automated by WeatherTRAK (Default Setting),
• Odd/Even,
• Interval or
• Days of Week.
To Next Page
Loading...