Communication Status Alert
The display will look like this:
This will appear if ET Everywhere service has failed to communicate
for 4 days. For these 4 days, WeatherTRAK ET plus will use the last
received ET to calculate programs. After 4 days, it will continue to
irrigate using the maximum backup ET from SETUP. The controller
will also beep as an audible warning that communications have been lost.
Using ET
ET is the position that you select when you want to view the current ET.
To do this:
1. Turn the Function Selector knob to ET.
2. Turn the Upper Line knob until you see:
This is the current daily ET stored in the controller. The lower
line shows the date and time the ET was received by the
controller.
3. Turn the Upper Line knob until you see:
This is the current weekly ET stored in the controller. The lower
line shows the date and time the ET was received by the
controller.
To Next Page
Loading...