Feature Adjust is Not Working
1. Turn the Function Selector to RUN.
Check the ”Date” and “Time” settings. Be sure they are correct.
2. Turn the Function Selector to REVIEW.
ADJUST changes may be subtle, shown as a small difference in
the runtime or number of cycles, or it may be more significant
depending on the percentage adjustment. If you are towards the
end of the week when reviewing the schedule (Wed. or later) the
affect of ADJUST may not be evident in the current week.
Remember, any days that have already irrigated will appear in
the REVIEW display regardless of any ADJUST. You should see
the effect of ADJUST in week 2, 3, etc. with different day intervals.
Controller Just Installed, Activated and Still Beeping
1. Turn the Function selector to RUN.
Check the “Date” and “Time” settings. Be sure they are correct.
2. Turn the Function Selector to RUN and hold down the Copy
button.
You will see “Phase X(L)” where “X” is one of the four phases
and the “L” signifies that the phase is locked. “Beep on message”
is automatically turned on when the installer locked on a phase
to activate. The installer did not turn off beep after activation.
The beeper will automatically turn off at midnight or go to
HELP, turn to “BEEP ON MESSAGE?” and set to “No.”
What the Beeps Mean
1. Two Beeps: a good message has been received for this controller.
2. Four Beeps: a good message has been received but it is for
another controller.
3. Six Beeps: a bad message was received and it will be ignored.
4. Alternating long and short beeps: The controller’s fuse has
blown and needs to be replaced. Replace the fuse. Fuses are
available from WeatherTRAK distributors. See “Appendix D: FCC
Information” on page 101.
5. One beep every 30 seconds: Communications to the controller
have not occurred for over 4 days.
Troubleshooting Guide 91
To Next Page
Loading...