9. Turn the Upper Line knob to the next position.
The phase options are “None,” “A,” “B,” “C,” or “D. “ When
locked on a phase other than “None,” “Beep on Message” will
turn on automatically.
10. Turn the Upper Line knob to the next position.
There is a blank screen before this. Two actions can be performed
here. One action is to restart the controller microprocessor,
retaining all of the programming previously completed. This is
called a “Restart.” A second action called a “Reset” can be
performed. This action will restart the controller microprocessor
and erase all of the programming previously entered into the
controller. You will be required to call HydroPoint Customer
Service and reactivate the controller. You should only do this
when directed by HydroPoint Customer Service.
HydroPoint Customer Service: (800) 362-8774.
Setting to Off
OFF stops all irrigation of your WeatherTRAK ET plus controller until
you return the Function Selector knob to RUN (or any other function
position other than OFF.)
Turn the Function Selector knob to OFF.
The display will look like this:
The upper line of the display shows the date and time.
To Next Page
Loading...