4. Turn the Upper Line knob to the next position.
5. Turn the Upper Line knob to the next position.
6. Turn the Upper Line knob to the next position.
You enter the start time with the SETUP function.
7. Turn the Upper Line knob to the next position.
The default is “No.” The controller will beep when it receives
any message. If this is changed to “Yes,”at midnight it will revert
back to the default setting.
8. Turn the Upper Line knob to the next position.
The unit is gathering statistical data on the signal integrity of
each phase. It can take several minutes to acquire sufficient data.
To Next Page
Loading...