HydroPoint WeaterTRAK ET plus - Setting the Water District Number

Setting the Water District Number
(Option for Water Agency Program Participants)
HydroPoint provides a water district number if, and only if, you are a
registered and willing participant in a water agency program. During
activation, you will be instructed on what value, if any, should be
entered. This may be set manually. This identification will allow your
WeatherTRAK ET plus to be notified of specific water agency
requirements.
To set the water district number:
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select a number from “0” to “9.”
3. Continue to turn the Upper Line and Lower Line knobs until
you have selected the correct five-digit number.
Important:
There are some menu displays that you will set later. The following
settings are not mandatory and will be covered in Chapter 4.
!
SET WATER DIST.# Digit 1
12345
–
Setting Up Your WeatherTRAK ET plus 21