User Program No ET
To program without ET, you must figure out the entire irrigation
schedule (cycle time, number of cycles per operating day, soak time
and days of operation) and enter it into the controller.
Unless you change it, the schedule remains the same.
This mode is different from the “User Programmed--With ET Mode”
in that the irrigation schedule is not modified by daily ET Everywhere
service. Stations in this mode will run according to the start times
that you entered in SETUP.
Remember that stacking is a sequential operation and non-stacking is
a simultaneous operation.
Important:
The steps to program your controller without ET are the same as
programming with ET.
Follow the same steps for programming with ET if you wish to
program without ET.
Copying
This feature lets you copy the information you entered for one station
to another station, multiple stations, or all stations. The information
can then be edited as required. This speeds up programming and
minimizes your chances for error.
Occasionally, you may wish to erase all of the programming you
entered in your WeatherTRAK ET plus controller and start over. You
can easily do this with “Copy Program Defaults.” Or, you may want
to start over with the SETUP defaults. You can do this by using
“Copy Setup Defaults.”
The steps for using the COPY feature include:
1. Copy From the Station Number
Set the source station with the Upper Line knob.
2. To Station Number (Press the Copy button)
Set the destination station(s) with the Lower Line knob, then
press the Copy button.
To Next Page
Loading...