The “User Programmed--NO ET” mode does not use ET Everywhere
service and the program remains unchanged unless you change it.
This mode always applies the same amount of water regardless of
changing weather and changing landscape requirements.
Fully Automated Program
With this method, the design of the irrigation program is completely
automated based on parameters that you select. (The irrigation
program is automatically adjusted by ET Everywhere service updates.)
Once you have set the parameters, WeatherTRAK ET plus will adjust
the watering programs in response to changing weather conditions
throughout the year.
WeatherTRAK ET plus uses a 50% soil moisture depletion model to
determine when and how much to water each plant type. When the
soil reservoir has depleted to 50% of its capacity, the controller will
irrigate.
There are 14 steps to program each station on your controller using
the fully automated feature.
They are:
1. Set Station to Program
You program one station at a time.
2. Set Program Mode
You set the controller to “Fully Automated” program mode.
3. Set Schedule
You assign a schedule, A or B, from one that you have already
created.
4. Use Water Window
You tell the controller whether or not you want to use the water
window defined during setup.
5. Set Sprinkler Type
You select the kind of sprinkler heads you will be using.
Programming Your WeatherTRAK ET plus 31
To Next Page
Loading...